Take your Ender 3 V3 SE to the next level with the Unicorn Nozzle quick swap hotend. This upgrade allows for easy and rapid nozzle changes, saving you time and increasing your printing efficiency. This guide provides a step-by-step walkthrough of the installation process, helping you to successfully upgrade your hotend and enjoy the benefits of quick swap nozzle technology.
TABLE OF CONTENTS
Documentation Note:
We highly suggest PID autotune on the new hotend (https://support.dremc.com.au/support/solutions/articles/51000266870-pid-calibration ) and double your slicer retraction length is <1.5mm and speed may need to tuned further depending on your printing speed/material)
If you have stock, you would follow Marlin Guide, if upgrading or using KE with Neblua Pad it would Klipper or depending on version these function may be available through the screen or over WIFI over web UI via command terminals.
Note: The nozzle is only required to be hand tightened or lightly with tool, <1nm cold and ensure you secure heater block to prevent stripping the nozzle or hotend mount when tightening using a tool.
Part Referenced:
Hotend: https://store.dremc.com.au/products/ender-3-v3-se-ke-ceramic-heating-block-kit-quick-swap-nozzle-kit
Install Video:
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article