General Troubleshooting

PID Calibration
Have you just purchased a new nozzle or hotend or replaced a new bed?    You may need to require reconfigure PID to ensure the nozzle/bed temperature is n...
Sun, 21 Jan, 2024 at 9:52 PM
Testing the thermistor resistance
Before you install your thermeristor, you should double check that you both purchased and received the working before installing. Apply the multimeter probe...
Sat, 3 Feb, 2024 at 11:55 PM
Testing the Heater Cartridge Resistance
Before you install your heater cartridge, you should double check that you both purchased and received the correct voltage cartridge. Cartridges are laser e...
Tue, 13 Jun, 2023 at 9:56 AM
3D Printing Calibration
Teaching Tech (Youtube: Link) has a great resources on his github/webpage. If you have any suggestion, please submit to his github issues : Submit Issue ...
Thu, 21 Sep, 2023 at 9:43 AM
3D Printer Troubleshooting
Teaching Tech (Youtube: Link) has a great resources on his github/webpage. If you have any suggestion, please submit to his github issues : Submit Issue ...
Sun, 26 Dec, 2021 at 12:29 PM
Help! I've got a clog in my hotend! What do I do now?
Steps for Resolving a Hot-End Clog, follow each sequentially until the issue is resolved: Gradually heat the hot-end to a temperature approximat...
Wed, 7 Feb, 2024 at 11:18 PM
How to hot tighten nozzle / Change a nozzle
You should always perform a hot tighten of nozzle when changing or installing a new hotend. It always best to remove/change nozzle when hotend is hot....
Wed, 29 Mar, 2023 at 10:03 AM
Re-Pin Stepper Motor Connector
Mainboard End Using the image as guide, swap the green wire with the red. Here is how to do it: push the red wire further into the connector pus...
Tue, 11 Oct, 2022 at 7:48 PM
Stepper Motor Wiring
Stepper Cable JST-PH6 to PC2510 Stepper Motor side PIN 1 – A PIN 2 PIN 3 – B PIN 4 – C PIN 5 PIN 6 – D                               ...
Fri, 19 May, 2023 at 2:43 PM
Functional Print Tuning
Our recommendation for print tuning, it written with Voron in mind but suitable for all printer running on Marlin/Klipper.  Guide: https://ellis3dp.c...
Sat, 25 Feb, 2023 at 6:24 PM