Proper cooling is essential for print quality on your Flashforge Adventurer 5M or 5M Pro. If you're experiencing heat creep, stringing, or unusual fan noise, or if a fan has stopped spinning entirely. You may need to replace the failed unit is the most effective solution . This guide walks you through replacing both the part cooling fan (typically a 4020 or 5020 blower fan) and the hotend cooling fan (the axial fan cooling the heat sink) on your Adventurer 5M Series . Using basic tools (primarily a small Phillips head screwdriver), you'll learn how to safely remove the print head, disconnect the fan wiring, install the new genuine or compatible replacement fan, and properly route cables before reassembly . Always power off and unplug your printer before starting any maintenance, and note that the 5M and 5M Pro may use different fan sizes, check your physical fan before ordering a replacement.
TABLE OF CONTENTS
Spare Part Referenced:
Spare Part (Part Cooling Fan)
Spare Part (Hotend Cooling)
Video (Part Cooling Duct and Hotend Fan):
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article