Creality All Metal Direct Drive Sprite Extruder Pro Kit Install Guide

TABLE OF CONTENTS

• Part Referenced:
• Install Video:
• Written Guide: 

Part Referenced:

https://store.dremc.com.au/products/creality-direct-drive-sprite-extruder-pro-kit-for-ender-3

Install Video:

Note: New e-step value: 429.9

Written Guide: 

See attached below attached file written install guide or click this link for manual pdf. 

Note: New e-step value: 429.9

Additional Notes:

1. We do recommenced doing a PID auto tune to most common temperature (PID Auto Tune Guide)
2. You will need to re-level your bed or updated your z-off set if you're using a BL Touch/CR Touch, the breakout cable for bl touch/cr touch is not included, you would need to run these cable back to mainboard.
3. Plug in your heater, as some batches have heater unplug from breakout boards.