Is your Ender 3 S1, S1 Pro, or S1 Plus suffering from clogs, temperature fluctuations, or physical damage after a print failure? Replacing the entire hotend assembly on the Sprite extruder is often the most effective solution . This guide walks you through replacing the complete hotend unit which including the heating block, heat break, thermistor, heater cartridge, and nozzle with a genuine Creality replacement kit designed for the S1 series . The process is generally straightforward, taking around 10-15 minutes, and involves disconnecting the wiring, removing two screws, and installing the new unit before performing a PID tune . A critical note: later models of the Ender 3 S1 series have a different thermistor interface; please verify your printer's version before purchasing a replacement to ensure compatibility or you may need replace to older PCB Board.
TABLE OF CONTENTS
Spare Part:
Ender 3 S1 Series Hotend Sub Assembly.
Install Video:
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article