Follow the official Creality video with a few different steps below
220V Connection:
1. Connect 2 white wires to N and 220B slots on SSR. Connect the yellow grounding wire to SSR (grounding wire has a ring terminal).
2. Isolate and DO NOT connect the 110v yellow wire.
3. Connect thermistor to the mainboard.
110V Connection:
1. Connect 110v yellow wire (fork teminal) to N slot, connect 2 white wires together to 110B slot on SSR. Connect the yellow grounding wire to SSR (grounding wire has a ring terminal).
2. Connect thermistor to the mainboard.
Rigid bed mounts
If you use stock bed probe (PRTouch) then use metal standoffs with M4*30 bolts.
Springs and knobs
If you use cartographer or other Eddy sensor bed probes, then you may use springs with M4*40 bolts with bed knobs for easy bed leveling using screw tilt adjust. You may buy the bed knobs or print the knobs from Printables.
Thermistor type
You need to make changes in printer.cfg file. Find heater_bed section and change senosr type to "sensore_type: Generic 3950".
You may change the max_temp to 130 to be able to heat up the bed to higher temperatures.
Temperature Error
If you see negative temperature readings and printer throws temperature errors, that means that you did not change the thermistor type in the config file. See the previous step.
PID Calibration
The heater is more powerful than the stock heater. You need to run PID calibration in console by copy/pasting the command: “PID_CALIBRATE HEATER=heater_bed TARGET=70”. Then SAVE and restart
Need help?
If you have question and/or need help, please, join D3vil Design Discord. We have lots of great people! You can find help, 3D printer mods and learn a lot about 3D printers and printing.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article