How to remove your heater/temperature sensor once the Boron Nitride Paste has dried?

Modified on Wed, 26 Jan, 2022 at 7:07 PM

If you are reading this article, odds are that you are trying to remove your heater or temperature sensor from your hot block. If you add Boron Nitride Paste into the mix, you might feel like your components are permanently stuck in the hot block. Luckily, we have some techniques/tools to remove your components:


For Temperature Sensors:

Use an Allen key about the size of your temperature sensor and try to lightly tap the sensor out.


For Heaters:

For the heater, we have a printable Heater Unseater that you can use to remove the heater. To use the Heater Unseater simply print it, grab it (with pliers) and unseat it.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article