TABLE OF CONTENTS
Revo Brass / HT / HTA Nozzles
Recommended cleaning methods:
Nylon cleaning filament
Warm pull (Internal cleaning)
Cold pull (Internal cleaning)
Brass brush (External cleaning)
More Information for Cold Pulls: https://support.dremc.com.au/en/support/solutions/articles/51000285907-help-i-ve-got-a-clog-in-my-hotend-what-do-i-do-now-
Not recommended:
Needle (Internal cleaning)
Steel wire brushes (External cleaning)
Blow torch (Internal/ External cleaning)
Revo ObXidian Nozzles
Recommended cleaning methods:
Nylon cleaning filament
Warm pull (Internal cleaning)
Cold pull (Internal cleaning)
Brass brush (External cleaning)
More Information for Cold Pulls: https://support.dremc.com.au/en/support/solutions/articles/51000285907-help-i-ve-got-a-clog-in-my-hotend-what-do-i-do-now-
Not recommended:
Needle (Internal cleaning)
Steel wire brushes (External cleaning)
Blow torch (Internal/ External cleaning)
The hardness of the ObXidian coating can cause small particles to detach from the bristles of the brass brush and create dusting over the nozzle. This will give the nozzle a brass-coloured sheen. However, the coating itself is still very much intact, and there will be no compromise to wear performance.
IPA/Acetone may be used to clear clogs, and it will not damage the E3DLC coating.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article