Main attributes

  • Textured finish
  • Thinner than its smooth.
  • Ideal for extensive printing of PETG, CPE, TPEE/TPU.
  • No need for glue stick with flexible filaments (TPU/TPEE)
  • Prints automatically detach after the sheet cools down
  • To be cleaned with ~90% IPA or deneutered alcohol when cold. Do not use anything made for skin! It can contain oils/sugars that ruin adhesion!


Do:

Degrease the sheet with isopropyl alcohol (IPA) 90%+

Print without any adhesive or separation layers

Print supported materials (PETG, PLA, PC, CPE, PVA/BVOH, HIPS, Flex, nGen, Nylon)

Remove prints after the cooldown

Bend the sheet to remove printed objects


Don’t:

Use acetone and other agents

Print with adhesive or separation layers

Wash the sheet with water

Remove printed objects before cooldown

Use any instruments (spatula) to remove the printed object




Prints don’t stick

If your print surface is perfectly clean and all grease has been removed by wiping it with a paper towel soaked in isopropyl alcohol ~90%. Also, make sure the first layer height is set up perfectly.


If your prints still do not adhere reliably to the print surface, try to wash the sheet in warm water with a few drops of liquid dish soap (not hand soap). This can clean away oils/sugars that are not affected by rubbing alcohol. However, the textured sheet is not water-proof so consider this a last resort which should not be done often.



Note:

PEI sheets (smooth, textured, etc.) are not covered by warranty as the coatings are designed to diminish over time unless failure has occurred due to a defect in materials or workmanship. Cosmetic damage, including but not limited to scratches, dents, cracks or other cosmetic damage is also not covered by the warranty. Only defective sheets on arrival are covered by warranty.