DREMC PBT GF First Layer Printing Guide

Modified on Thu, 3 Apr at 7:56 PM

First Layer Bed Adhesion Table:


Due to the properties of PBT GF, it offers relatively low bed adhesion to most build plates. It is highly recommended that you use one of the tested first-layer solutions listed below. Other filaments may also be suitable, but we have not attempted or tested them. If you achieve success, feel free to contact us and share a test print photo. 


We recommenced either 2-3 layers minimal for first layer to ensure a good adhesion.


First Layer MaterialsBuild PlateBed Adhesion
Printer
DREMC PC ABS (110c Bed)Black Textured PEI (DREMC)Magigoo PC or Magigoo OriginalVoron Trident (Profile - based on Super Slicer 2.7 Beta )
DREMC ABS+ (110c Bed)Black Textured PEI (DREMC)NoneVoron Trident (Profile - based on Super Slicer 2.7 Beta)
Sunlu ABS (N/A)Golden Textured PEINoneVoron Trident Idex (Tester)
DREMC ABS+ (100c Bed)Black Textured
NoneBambu X1 (Bambu Slicer Profile)
DREMC ABS (110c Bed)Black Textured (Bambu)Magigoo OriginalBambu P1 (Tester) 

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article