DREMC Filament 3D Printing Profile
These printer/material profile are meant to help you find the best print settings for your needs. Different printers and hot-ends or modification may requir...
Sat, 8 Jun, 2024 at 7:40 PM
Filament Drying Time Recommendation
Drying Time Recommendation Note: If you cannot reach dryer listed temperature, set to max temperature and double below time for every 5 degrees below re...
Thu, 2 May, 2024 at 1:03 PM
DREMC Filament Technical Datasheet and Safety Sheet
The typical values presented in this data sheet are intended for reference and comparison purposes only among DREMC range. They should not be used for desig...
Fri, 24 May, 2024 at 11:19 PM
Guide to Functional Printing
Part Cooling: When printing for functional parts it’s best to print for strength it’s best to go hotter and low to no part cooling fans. To maxi...
Thu, 26 Oct, 2023 at 6:24 PM
Guide to printing PLA Filament
PLA is most common FDM 3D Printer materials and essentially all print should yield great results. Polymaker filament is a semi-crystalline plastic and is on...
Thu, 18 Jan, 2024 at 10:49 PM
Guide to printing PETG Filament
PETG is a glycol-modified variant of PET (Polyethylene Terephthalate) and the most popular material in the PET family of plastics. The glycol in PETG offers...
Sun, 15 Oct, 2023 at 6:10 PM
Guide to Printing ABS Filament
TABLE OF CONTENTS Introductions Requirements Printer Setup  Loading and Unloading Filament Bed Surface Bed Leveling & Nozzle Height Filament Sto...
Fri, 20 Oct, 2023 at 11:10 PM
Polymaker PolyMide Nylon CoPA
Printing Settings Nozzle Temperature 250˚C - 270˚C  Build Surface Material Almost any surface (I.e Glass, Buildtak etc.) Build Surface Treatment P...
Sat, 25 Jun, 2022 at 10:45 PM
ABS/ABS+/ASA Post ​Processing
Ensure proper PPE is worn when post processing ABS/ABS+/ASA according to AS/NZS 1716 & 1715.
Thu, 18 Jan, 2024 at 10:47 PM
PolyMaker PolyWood Print Settings
Printing Settings Nozzle Temperature 190°C - 220°C Build Plate Temperature 25°C - 60°C Build Surface Material Works well with most build surfaces i.e Glass,...
Sat, 25 Jun, 2022 at 10:40 PM