How to replace Filament First Stage Feeder for CFS

The first stage feeder in the Creality Filament System (CFS) is a motorised component responsible for automatically feeding filament from the spool to the printer's extruder and retracting it during filament changes . If you encounter clicking noises, failure to load filament, or error messages related to filament feed, the first stage feeder may need replacement . This guide provides step-by-step instructions for safely removing the old feeder unit and installing a new genuine Creality replacement part for your K2 Plus CFS.

TABLE OF CONTENTS

• Spare Part: 
• Install Video:
• Written Guide:

Spare Part: 

Replacement First Stage for CFS

Install Video:

Written Guide:

Source: https://wiki.creality.com/en/cfs/filament-inlet-of-cfs

Note: Ensure CFS is powered off, and filament unloaded and removed from each channel. 

1 Unplug four PTFE tubes

Remove four screws

2 Pull out the entire filament inlet

Place the entire CFS box upright, manually pull out the entire filament inlet

 3 Unplug the cable

Remove the cable cover, unplug the cable from the motor adapter board

 4 Remove the entire filament inlet

5 Remove two screws & unplug the cable

Locate the filament inlet that needs to be replaced, unscrew the fixing screws, and remove two cable wires.

6 Remove the filament inlet that needs to be replaced

Remove the filament inlet to be replaced along the direction of the PTFE tube.